first gear造句

• Leave the vehicle in first gear and apply the handbrake firmly
  停车后入一档，并拉紧手掣。
• Who never take her out of the first gear . - half a mil for a car
  -开车从来没起超过一档-一辆车五十万？
• The operator should have placed the vehicle in lockup and in first gear
  操作人员应该将车辆锁定在一档。
• Fgs first gear switch
  第一挡位开关
• There is only one way to get through that turn , in first gear , after downshifting from fourth
  这是唯一的办法通过那个弯角，在四档之后立刻减到一档。
• By client basis oneself risk is mixed the ability that pay fee , choose first gear to cast at least protect
  由客户根据自身风险和交费能力，至少选择一档投保。
• It is as if the human form starts their ascension in reverse , and before it can even think of moving into first gear , the form must be resurrected
  就象人类形态开始逆方向提升一样，甚至在它考虑进入第一个齿轮前，形态就必须复兴。
• " it tents to get stuck in first gear , has trouble changing direction , hesitates when the road gets rough and never seems to reach its destination . it is a company car .
  好像第一节齿轮卡住了，有困难改变方向。考虑道路粗糙，似乎不能到达目的地。那是公司的车。
• It tends to get stuck in first gear , has trouble changing direction , hesitates when the road gets rough and never seems to reach its destination . it ' s a company
  第一次启动往往打不开,方向盘存在问题,道路崎岖不平时容易抛锚,似乎永远也到不了终点.公司汽车就是这样
• Team mate christian klien suspected that he broke first gear in the hairpin at that stage , which was why he ran wide and surrendered a place to coulthard
  队友克里斯蒂安-克莱恩在那个阶段的发夹弯怀疑自己弄换了第一挡，那就是为什么他走线太宽并失去一个位置给库塔的原因。
• This paper trice to find the cause of effective ness loss and to analyze it theoretically by adopting the ways of quantitative analysis and quantitative analysis by using the way of fault tree to carry out the qualitative analysis , it draws the logic charts by various elements that cause the loss of effectiveness and to make a faucet tree to find out the loss programs , then make a final analysis of the smallest element of the fault tree . the first problem is due to the over friction by exceeding permitted limits ; the second problem is due to the gear feather ' s low inteusity , this paper adopts the method of changing the trans mission ratio of the first gear and the width of the sixth gear of second shaft so as to solve the problems
  本文采用定性和定量相结合的方法，利用失效树进行定性分析，它通过对可能造成系统失效的各种因素，画出逻辑框图，从上到下绘成失效树，找出失效谱，并对失效树的全部最小割集进行分析，找出有可能的失效原因，再对其通过理论计算进行定量分析，由此发现第一个问题是由于离合器在极限状况下的滑磨功超过其许用值造成的，第二个问题的原因是二轴六档齿轮强度不足。